Head
Tuning machines: Die-cast Grover tuners with 18-1 ratio.
Neck
Hand filed frets. Set Neck. 22 frets. Nut made of Graphite. The neck is made of Maple. The fingerboard is made of Rosewood. The neck is bound. The fingerboard is inlaid. (trapezoidal inlays).Neck radius is 13.7" (350mm).
Body
Body width is 13. Bound body. Body is made of Mahogany. Top of the body is made of Maple. No pickguard on this model.
Electronics
Magnet: Ceramic, Coil 42awg (.063mm) Neck: Inductance: 4.85 Henrys, DC Resistance: 7.8k ohms Turns 5,550 Bridge: Inductance 8.7 Henrys DC Resistance: 8.7k ohms Turns 6,050. Configuration: HH. AL-Hot High Output Ceramic Pickups. Volume controls: 2. Tone controls: 2. There is a pick-up selector. The pick-up selector has 3 positions.
Hardware
Bridge: Bridge pole spacing is 3\". Stop/tail part: Tail piece pole spacing is 3 1/4.
:
Picture below courtesy Rondo Music Web Site
:
Picture below courtesy Rondo Music Web Site
:
Picture below courtesy Rondo Music Web Site
:
Picture below courtesy Rondo Music Web Site
:
Picture below courtesy Rondo Music Web Site
:
